![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
![](c.gif) |
|
My
Garage |
|
|
|
<
-------------------------------------------------------------------------------------------------------------------> |
|
|
|
It really is not hard to get
an engine out of a fiero, when you remove the rear bumber and use an
engine hoist to lift the back end 6 ft in the air. |
|
|
|
![](hmm__where_did_the_back_end_go.jpe) |
|
|
|
The entire center
consol must be removed to run the cables and install the 4spd
shifter |
|
|
|
Links to Other Pages |
|
|
|
|
![](Center_Totally_apart.jpe) |
|
|
|
|
|
|
|
|
|
Home |
|
|
|
|
|
Trans |
|
|
|
|
|
2.8 HO specs |
|
|
|
|
|
captfieroofbc@home.com |
|
|
|
Email: |
|
|
|
|
|
|
|
|
|
This is the new
motor on the engine stand waiting for the last little bits to be put
on. |
|
|
|
This is the old
motot on the cradle. |
|
|
|
|
|
![](Old_Motor_OOOH_bad_motor.jpe) |
|
|
![](New_Hot_Rod_2.9_Yee_Haw.jpe) |
|
|
|
|
|
|
Trust me when I say you
got to take most of the interior out to swap from auto to 4spd. |
|
|
|
![](and_this_is_halfway_back_together.jpe) |
|
|
|
<
-------------------------------------------------------------------------------------------------------------------> |
|
|
|
|
|